Beezyhives

Oxalic acid trickling

Winter treatment against varroa when the colony is broodless. It is over 90 per cent effective.

By , beekeeper · Updated · Dansk

This guide is based on Danish conditions and rules. Rules, products and timing in your country may differ.
  • Timing: usually in December, when the colony is broodless.
  • Dose: follow the package leaflet for your product. The dose is given per seam of bees and depends on the product, so count the seams before you start.
  • Trickle the solution directly onto the bees in the seams. This can be done even when it is cold.
  • Use an approved product and follow the package leaflet. Do not repeat the treatment too soon.
  • Wear acid-resistant gloves and safety goggles.

Record the treatment in the app. It will then be included in your medicine log and you will get a reminder to count the mite drop afterwards.

Guidance on varroa.dk ›

Why does oxalic acid work best in winter?

Oxalic acid only reaches the mites sitting on the bees. Mites inside sealed brood are protected by the cappings. The effect is therefore greatest when the colony is completely broodless, usually in December after a spell of frost. Then almost all mites sit on the bees, and a single treatment can remove more than 90 per cent.

If the colony still has brood, for example after a mild autumn, you can wait a couple of weeks, or treat anyway and accept a lower effect. Check the floor insert first: lines of wax cappings under the frames mean brood is still emerging.

Step by step

  1. Pick a day above freezing, ideally 2 to 8 °C, when the bees sit calmly in the cluster.
  2. Mix or warm the product according to the leaflet. A lukewarm solution makes the bees less restless.
  3. Take off the roof and crown board, and count the seams with bees in them.
  4. Trickle the stated amount per seam directly onto the bees. Do not trickle into empty seams.
  5. Close the hive straight away. The whole treatment takes less than a minute per hive.
  6. Put in a clean floor insert, and count the mite drop after about a week.

Safety

Oxalic acid is corrosive. Wear acid resistant gloves and safety glasses, and keep water nearby for rinsing. Store the solution out of reach of children, and do not pour leftovers into nature. If you get solution on your skin, rinse thoroughly with water.

Trickle only once per winter. Repeated trickling shortly after each other harms the bees more than the mites. If you want to treat again, wait for the next broodless period, or choose another method.

Read next

Oxalic acid calculator: dose per seam and hive ›

Treatment records for beekeepers ›

Frequently asked questions

When in the year should I trickle oxalic acid?

When the colony is broodless, in northern Europe typically in December and sometimes early January. A week or two after the first real frost is a good rule of thumb.

Can I trickle when it is freezing?

The treatment can be done in cold weather, but it is gentlest on a day a little above freezing, when you can open the hive briefly without the cluster breaking up.

How many mites should fall?

It depends on how many there were. Under 200 mites in the drop after trickling is low. If many thousands fall, the colony was heavily infested, and you should be extra careful with drone frames next spring.

Do I need to record the treatment?

In most countries, yes. Oxalic acid products for bees are approved veterinary medicines, and every treatment should be recorded with date, hive, product, dose and batch number.

Get it all as reminders

Beezyhives creates tasks automatically from the season and your inspections, shows when the weather is best for inspecting, and keeps your treatment records for you. Free for 30 days, email only.

Try Beezyhives free

Got a question? Ask it in our Facebook group for beekeepers.

More guides for beekeepers